打抜き動画一覧
Comparison of bevels and thickness_3 slip sheet 1.8mm
2016-02-16
This is a comparison of punching operations by our cutting rule.
You can see the differences in bevels and thickness.
・Cutting rules used in video:
1. NCD 0.9×23.6 (∧55°)
2. NCD 0.7×23.6 (∧53°)
3. NCD-MIR 0.7×23.6 (∧42°)
4. NCD-MIR 0.5×23.6 (∧42°)
・Material: 3 slip sheets(Thickness:1.8mm)
☆Please pay attention the differences of shear droop.☆
Punching PP by D-MIR 18P
2016-01-18
This is a cross section image punching PP by D-MIR 18P.
- Cutting rule : D-MIR 18P
- Material: PP1.8mm
☆Please pay attention that there are no burrs between cutting rule and PP.☆
Comparison of MIR & overseas manufacturers_package of cigarettes 0.35mm
2014-12-22
This is a comparison of punching operations by our cutting rule "MIR" and overseas manufacturers' one. You can see images of cross section at last.
- Cutting rule : (left)Nakayama NC-MIR 0.7×23.8 5075 ∠53° (right)Overseas 0.7×23.8 4570 ∠53°
- Punched material: package of cigarettes(titanium oxide coating)0.35mm
☆Please pay attention images of cross section.☆
Comparison of punching operations
2012-04-05
Compare punching operations (by MIR-CI23 and Silky Coating MIR-CI23) Silky Coating is highly evaluated in various fields; if you have any doubt about the value of Silky Coating, please watch this video.
- STEEL RULE A : MIR-CI23 (白) 0.7×23.6
- STEEL RULE B : Silky Coating MIR-CI23 (白) 0.7×23.6
- Punched material: Touch panel