The information on this page is for reference; it may change according to your cutting conditions.
Please do not hesitate to contact us for further details.
*The information may subject to change without notice. Please check “What’s New” on this website or contact us directly.
- ● Vinyl chloride
- ● PET・PP
- ● Polycarbonate
- ● Styrene
- ● Plastic cardboard
- ● Acrylic
Guide to Select CUTTING RULES for Cutting Resin
|Resin||Material (Thickness)||STEEL RULES |
(Standard thickness: 0.7; Numerical figures
in parentheses indicate hardness.)
|Reason of Recommendation(for reference)|
|Vinyl chloride （PVC）||（~0.5t）||ACE80
|* Use these STEEL RULES according to degrees of bending.|
|（0.8t~）||NCD (Double Long Bevel)（5080・6080）|
NCD (Double Long Bevel)（5080・6080）
|* Resin is not hard; select a high-hardness STEEL RULE, considering its bendability.|
|NCD (Double Long Bevel)（6580）||* For getting cutting surface verticality|
|Polycarbonate||（~0.8t）||MIRーCＪ23||* Polycarbonate is light and hard; STEEL RULE with body hardness of 50° or more is needed.
(Note) It may be difficult to punch surface-treated sheets (hard coating sheets, etc.) by using STEEL RULES.
|（1.0t~）||NCD (Double Long Bevel)（5080・6080）
NCE (Triple Long Bevel)（6580）
|* NC-E (Triple Long Bevel) with sharper blade edge is more suitable. (The first blade edge angle of NC-D (Double Long Bevel) is 53°; that of NC-E (Triple Long Bevel) is 50°.)|
|Styrene (Wood rack panel)||ACE80
NCD (Double Long Bevel)（4580・5080）
|* When styrene thickness is approx. 5 t, adjust thickness of the veneer board to 16 t; if the edge sags, back blanking may be required.|
|Vacuum forming (PET, special resin, etc.),
|NCD (Double Long Bevel)(Thickness: 1.0; Hardness: 5072)
NEW CUTTER-PET (For A-PET, PP, PS, PVC, etc.) (Thickness: 1.0; Hardness: 5580/5080)
|HI-MIR||* For sharper cutting or preventing residue deposition|